Why doesn’t Pix4D respect the point cloud classes when creating the DTM? I have several places on a project where buildings or structures still have generated contours up to their height, instead of having a flat area for where the ‘hole’ should be. I edited the point cloud to fully classify the str…

Hey Mark, You can make these areas flat by editing the Densified Point Cloud and assigning these points to the Disabled Point Group. Then, you should process Step 3. again to regenerate the DTM and the contour lines. Let me know if this improves the final result.

I’m having exactly the same problem still. I’m doing as instructed above with no success. Any update when this will be corrected in the software? Regards Div

DTM creation problems

PIX4Dmapper PIX4Dmapper Questions/Troubleshooting

Daniel_Rico_Cordero July 5, 2019, 10:00am 4

Hello,

I suggest having a look at this topic where the same issue is discussed.

Thank you very much.

Regards.

Topic		Replies	Views
Pix4D not respecting the pointcloud classification to create the DTM PIX4Dmapper Questions/Troubleshooting	1	1610	December 13, 2018
DTM and Contours remain the same, despite having modified the Densified Point Cloud PIX4Dmapper Questions/Troubleshooting	23	3763	June 15, 2021
Point Cloud Classification Clean Up PIX4Dmapper Questions/Troubleshooting	12	3212	December 19, 2018
Surfaces and DTM generation PIX4Dmapper Questions/Troubleshooting	2	1215	June 6, 2018
Cannot remove trees (high vegetation) from DTM PIX4Dmapper Questions/Troubleshooting	15	2041	November 30, 2020

DTM creation problems

Related topics