I am new to Pix4D. After beginning a new project, I click on “Mosaic Editor” to edit my orthomosaic and my ortho is extremely small and I can not zoom in to the fine details. Any way to get the ortho to open larger where I can zoom in closer? Thanks

Hello @shawn.elmore , I would recommend you to go through our support article on How to edit the Orthomosaic .Before you start editing, make sure that the step 3 processing is completed. If that doesn’t solve your issue, can you forward the quality report and a few screenshots of the issue? Regards…

Test1_report.pdf (1.2 MB) [Capture 1] Capture 1 is what I get when I open Mosaic editor Also attached is the Quality Report. I asked several others that have and are very familiar with Mosaic Editor and they did not know why this was occurring.

Capture 2 is as close as I can zoom in on my ortho [Capture2.PNG]

Hello @shawn.elmore , You should be able to zoom further. You can use the scroll wheel on the mouse to zoom the orthomosaic. For example when you zoom to the maximum extend the scroll bar at shown in the figure below will gets smaller. [image]

What I posted is as far as I can zoom in. I have used the scroll wheel on the mouse to scroll in as close as it will let me. There is no other was to scroll in closer. I have tried everything I know to do to get it to scroll in. While working with other Pix4D users, when they open the ortho, it …

Mosaic Editor opening ortho

PIX4Dmapper PIX4Dmapper Questions/Troubleshooting

Topic		Replies	Views
Orthomsaic Editor not available PIX4Dmapper Questions/Troubleshooting	19	3583	December 18, 2019
Editing Ortho mosaic PIX4Dmapper	1	45	July 14, 2025
Problems with the mosaic editor PIX4Dmapper	3	412	May 5, 2021
Mosaic Editor PIX4Dmapper Questions/Troubleshooting	1	761	May 13, 2020
Orthomosaic editor missing PIX4Dmatic Feature Request	4	85	October 16, 2025

Mosaic Editor opening ortho

Related topics