Defining and Connecting Manual Tie Points (MTPs)

PIX4Dmapper PIX4Dmapper Questions/Troubleshooting
1

Hi Everyone,

I am attempting to create a base and fill my 3D texture mesh. I am referring to the documentation below, however the documentation is saying to add MTPs which have no xyz values and to connect them. It also says the MTPs should have the lowest altitude, but as they do not have xyz values, that doesn’t seem to make sense. I also can’t find any documentation on how to connect MTPs.

Any help would be greatly appreciated! Thanks!

2

I’m not sure I’m understanding your question correctly, but the articles below might be helpful. It explains how to create MTPs.

Kind regards,